The Centrifuge

Centrifuge
Major Landmark
Information
Location	Chroma City Fun Park
Purpose	Produces Ink from Graydian Sadness
Statistics
No. of Weaknesses	2
Of What Colour?	Yellow Blue
How Much?	50 Paint Points Each
Defence
Is it Defended?	No
Hazards	Spikes Stampers
Miscellenous
Prerequisites	Unlock Sector 3

The Centrifuge is the major landmark of Chroma City Fun Park and the main production facility for INKT's ink, as it produces concentrated ink from the sadness of the Graydians inside. It is an amusement ride that spins riders around using centrifugal force. Beneath the structure, there is a storage chamber of ink tanks collected from the full Graydian suits. As seen in the level cutscene, it seems that the ride is operated by a pull string.

Description

The Centrifuge sits above the holding cells and has the two main rollercoasters terminating on either side of the landmark. The base is circular and has a metallic black exterior, with colour/black pipes flowing down into the chambers. From the rollercoasters' terminals, pipes connect the terminals to the landmark's weak points. These pipes act as platforms, as they also have fences in the corner.

The upper foundation level is indented with a smaller diameter to its lower counterpart. The rides' platform sits on top of this section as an upside - down bowl. The surface itself is flat and has a large opening in the center for the rides' axle. This axle is attached to the main noticeable part, the enclosed section for the Graydians. The exterior has been plastered with the INKT logo. This also has two doors on either side of the section. The lower part of the top section is entirely black with the rest being grey all around.

Strategy

You would need to use the Z - Jump both times to get up onto the rollercoasters, which is located next to the landmark. Once at the top, you can either go left (if you're going for Blue), or right (for Yellow).

If you're going left, use the switches to deactivate sections of the spike traps. While they are deactivated, jump from paintbot to paintbot, avoiding the spikes. When you reach the third switch, you need to roll across the trap as quickly as possible as the time limit is very short. Follow the pipes to the weak point. When you're done, drop down and use the Z - Jump again, but this time, head right. Here, activate another switch to cross to the other side. Each plate will deactivate one after another, so follow the path; but don't get too close. At the end, you need to get past the stampers on the wall, as these can push you off the edge. You could jump on top of the stampers and make your way over to the end with that method. The last section is quite difficult as you would need to contend with both stampers and spike traps. Once you clear that, follow the pipes to the weak point and you're done.

Gallery